Strain Gauge Bridge Isolating Repeater attachement

Strain Gauge Bridge Isolating Repeater - D1063S

Input from Zone 0 (Zone 20), Division 1, installation in Zone 2, Division 2
Strain Gauge Bridge Transparent Repeater
Up to four 350 Ω load cells in parallel or up to six 450 Ω load cells in parallel or up to twelve 1000 Ω load cells in parallel
Broken field wire fault detection
High Accuracy
Three port isolation, Input/Output/Supply
EMC Compatibility to EN61000-6-2, EN61000-6-4
In-field programmability by DIP switch
High Reliability, SMD components
Simplified installation using standard DIN Rail and plug-in terminal blocks
250 Vrms (Um) max. voltage allowed to the instruments associated with the barrier.

The single channel DIN Rail Load Cell/Strain Gauge Bridge Isolating Repeater D1063S acts as a transparent galvanic isolated interface installed between a weighing indicator in Safe Area and a load cell (or group of load cells) in Hazardous Area; it appears at the terminals of the indicator as a single load cell equivalent to the one in the field.

Provides a fully floating power supply voltage with remote sensing capability to load cell located in Hazardous Area and repeats, while isolating, the mV signal output to drive a load in Safe Area depending on the host system reference voltage. Up to four 350 Ω load cells, or six 450 Ω load cells, or twelve 1000 Ω load cells can be connected in parallel. Voltage reference (Safe Area side) is DIP switch configurable to select internal or external (host system) supply. In addition a field wiring fault red LED indicates any wire break in the Hazardous Area side.

D1063_DTS0185_EN.pdf D1063_ISM0069_EN.pdf

No Product Accessories.

Power Bus Enclsoure

Strain Gauge Bridge Isolating Repeater - D1063S

D1063S

Configurations

Related Products

Strain Gauge Bridge Isolating Repeater

Isolating Repeater

Field Bud Isolating Repeater